Loading ...
Loading ...
Loading ...
Viewer Software
Introduction
5
5-3
Introduction
The Vibration Tester includes Viewer software that lets
you do tasks from a computer. With the basic features of
the software you can:
• import/export a Machine Setup from the Tester
• set up a new machine
• make a copy of a Machine Setup
• change a Machine Setup
• look at cited peaks graphs, vibration spectra, and
time waveforms
• zoom-in and zoom-out of data views
• make a backup of the diagnosis data from a
measured machine
• import and look at the thermographic image of a
machine
Additionally, you can configure the Machine Setups with
the software and export them to the Tester. This Machine
Setup procedure is much the same as the Machine Setup
wizard in the Tester. For external analysis of the fault
data, you can export the fault data, Machine Setup, and
diagnosis data, to send to a vibration test consultant.
System Requirements
The minimum PC system requirements to use the Viewer
software are:
• Operating system: Microsoft Windows 2000,
Windows XP, Windows Vista, Windows 7, or
Windows 8.1
• Minimum 1 GB RAM
• One USB port
• CD-ROM disk drive
PC Connections
To connect the computer to the Tester:
1. Power on the computer and the Tester.
2. Connect the USB cable to the USB ports of the
computer and the Tester as shown in Figure 5-1. See
the marking on the ends of the cable for identifying
the Type-A and Mini-B ends.
3. Install the supporting software and Viewer software
(if not installed already). See Install the Viewer
Software.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...