Loading ...
Loading ...
Loading ...
PERIODIC MAINTENANCE 2-61
Periodic Maintenance Procedures
Headlight Beam Horizontal Adjustment
•
Turn the horizontal adjuster [A] in both headlights in or out
until the beam points straight ahead.
If the headlight beam points too low or high, adjust the
vertical beam.
Headlight Beam Vertical Adjustment
•
Turn the vertical adjuster [B] in both headlights in or out
to adjust the headlight vertically.
NOTE
â—‹
ON high beam, the brightest points should be slightly
below horizontal with the motorcycle on its wheels and
the rider seated. Adjust the headlight to the proper an-
gle according to local regulations.
â—‹
For the US model, the proper angle is 0.4 degrees be-
low horizontal. This is 50 mm (2.0 in.) drop at 7.6 m (25
ft) measured from the center of the headlight with the
motorcycle on its wheels and the rider seated.
50 mm (2.0 in.) [A]
Center of Brightest Spot [B]
7.6 m (25 ft) [C]
Height of Headlight Center [D]
Side Stand Switch Operation Inspection
•
Raise the rear wheel off the ground with the stand (see
Rear Wheel Removal in the Wheels/Tires chapter).
•
Inspect the side stand switch [A] operation accordance to
below table.
Side Stand Switch Operation
Side Stand
Gear
Position
Clutch
Lever
Engine
Start
Engine
Run
Up Neutral Released Starts
Continue
running
Up Neutral Pulled in Starts
Continue
running
Up In Gear Released
Does not
start
Continue
running
Up In Gear Pulled in Starts
Continue
running
Down Neutral Released Starts
Continue
running
Down Neutral Pulled in Starts
Continue
running
Down
In Gear
Released
Does not
start
Stops
Down
In Gear
Pulled in
Does not
start
Stops
Loading ...
Loading ...
Loading ...