Loading ...
Loading ...
Loading ...
CRANKSHAFT/TRANSMISSION 9-11
Crankcase Splitting
•
Apply a non-permanent locking agent to the threads of
the breather plate bolts [A] and tighten them.
Torque - Breather Plate Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
•
Install the breather side plate [A] so that the plate hole [B]
fit the projection [C] of the upper crankcase.
•
Apply a non-permanent locking agent to the threads of
the breather side plate bolt [D] and tighten it.
Torque - Breather Side Plate Bolt: 5.9 N·m (0.60 kgf·m, 52
in·lb)
•
Press the fitting [A] in the upper crankcase [B] until it is
bottomed.
Special Tool - Bearing Driver Set: 57001-1129
•
Press the plug [C] in the upper crankcase so that the plug
is deeper than crankcase surface.
•
Press the new needle bearing [A] for the shift shaft so that
its marked side faces outside and its surface [B] is flush
with the end of the hole.
•
Install the new oil seal [C] so that its surface [D] is flush
with the end of the hole.
•
Apply grease to the oil seal lips.
•
Apply a non-permanent locking agent to the oil passage
plugs [A], and tighten them.
Torque - Oil Passage Plugs: 20 N·m (2.0 kgf·m, 15 ft·lb)
•
Install the oil passage plug [B] in the lower crankcase, and
tighten it.
Torque - Oil Passage Plug: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Loading ...
Loading ...
Loading ...