Loading ...
Loading ...
Loading ...
PERIODIC MAINTENANCE 2-15
Periodic Maintenance Procedures
Idle Speed Inspection
•
Start the engine and warm it up thoroughly.
•
With the engine idling, turn the handlebars to both sides
[A].
If handlebars movement changes the idle speed, the
throttle cables may be improperly adjusted or incorrectly
routed, or damaged. Be sure to correct any of these
conditions before riding (see Throttle Control System
Inspection and Cable, Wire, and Hose Routing section in
the Appendix chapter).
WARNING
Operation with improperly adjusted, incorrectly
routed or damaged cables could result in an unsafe
riding condition. Follow the service manual to be
make sure to correct any of these conditions.
•
Check the idle speed.
If the idle speed is out of specified range, adjust it.
Idle Speed
Standard: 1 100 ±50 r/min (rpm)
Idle Speed Adjustment
•
Start the engine and warm it up thoroughly.
•
Turn the adjusting screw [A] until the idle speed is correct.
Open and close the throttle a few times to make sure that
the idle speed is within the specified range. Readjust if
necessary.
Throttle Control System Inspection
•
Check that the throttle grip [A] moves smoothly from full
open to close, and the throttle closes quickly and com-
pletely by the return spring in all steering positions.
If the throttle grip does not return properly, check the throt-
tle cable routing, grip free play, and cable damage. Then
lubricate the throttle cable.
•
Check the throttle grip free play [B].
Throttle Grip Free Play
Standard: 2
∼ 3 mm (0.08 ∼ 0.12 in.)
Loading ...
Loading ...
Loading ...