User Manual - Page 89

For 2020 JEEP WRANGLER.

Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 87
RAISING THE WINDSHIELD
1. Release the strap that secured the windshield in the
lowered position.
2. Raise the windshield.
3. Using the provided #40 Torx head driver, reinstall the
four Torx screws located along the interior of the
windshield. Secure them until they are snug, being
careful not to cross-thread the screws or overtighten.
Interior Torx Screw Locations
4. Reinstall the windshield wiper arms using the
provided 15 mm socket. First, align the tips of the
blade to the T” mark in the glass. Then, while holding
the arm in that position, reinstall the hex nut and
tighten until snug. Be careful not to over-tighten.
Repeat for the other arm.
5. Reinstall the protective caps over the wiper arm hex
bolts and push gently until they snap into place.
Protective Cap Over Wiper Bolt
6. After completing the steps above:
If your vehicle is equipped with a Soft Top, reinstall
the Door Rails and raise the top.
If your vehicle is equipped with a Hard Top, rein-
stall the Freedom Panels.
HOOD
OPENING THE HOOD
Release both the hood latches.
Hood Latch Locations
Raise the hood and locate the safety latch, located in the
middle of the hood opening. Push the safety latch to the
left side of the vehicle, to open the hood. You may have to
push down slightly on the hood before pushing the safety
latch. Unhook the support rod from the hood and insert it
into the slot on the front end above the radiator.
1 — Outer Torx Screws
2 — Center Torx Screws
2
20_JL_OM_EN_USC_t.book Page 87
Loading ...
Loading ...
Loading ...