Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 53
3. Insert the right side Freedom Top panel into the bag
with the latches facing downward.
Right Panel — Latches Facing Downward
NOTE:
Ensure the front Freedom Top panel latch is closed prior
to inserting the panel into the bag.
4. Unfold the outer flap and zip the Freedom Top bag
closed.
Storage Bag Closed
5. Lift the Freedom Top bag into the vehicle with the
hooks and straps facing the back of the rear seat.
Attach the clip at the bottom of the bag to the child
restraint anchorage, located at the base of the rear
seat.
6. Wrap the upper strap around the rear head restraints
and loop the strap through the buckle. Pull on the
strap to tighten the Freedom Top bag securely
against the rear seat.
FRONT PANEL(S) INSTALLATION
1. Set the right side panel on the windshield frame with
the locating pin in the front receiver mounting hole
followed by the left side panel, making sure there is
no overhang. Also, make sure that the panels are
sitting flush with the body.
2. Reinstall the panel(s) using the same steps for
removal in reverse order.
NOTE:
To prevent water leaks, the seals and Freedom Top Panels
should be clear of any dust and debris prior to re-instal-
lation.
REAR HARD TOP REMOVAL
Use this QR code to access your digital
experience.
1. Remove both front panels. Refer
to “Front Panel(s) Removal” in
this section.
2. Open both front doors.
3. Using the provided #50 Torx head driver and ratchet,
remove the two Torx head screws that secure the
hard top at the B-pillar (near the top of the front
doors).
Step Three
4. Remove the six Torx head screws that secure the hard
top to the vehicle (along the interior bodyside — three
screws on each side) using the #50 Torx head driver.
Step Four
2
20_JL_OM_EN_USC_t.book Page 53
Loading ...
Loading ...
Loading ...