User Manual - Page 17

For 2020 JEEP WRANGLER.

Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 15
HOW TO USE REMOTE START
Push Remote Start button on the key fob twice within
five seconds. Pushing the Remote Start button a third
time shuts the engine off.
To drive the vehicle, push unlock button, and place the
ignition in the ON/RUN position.
With remote start, the engine will only run for
15 minutes (timeout) unless the ignition is placed in
the ON/RUN position.
The vehicle must be manually started with a push of
the START/STOP ignition button after two consecutive
time outs.
All of the following conditions must be met before the
engine will remote start:
Gear selector in PARK
Doors closed
Hood closed
Swing Gate closed
Hazard switch off
Brake switch inactive (brake pedal not pushed)
Battery at an acceptable charge level
Panic button not pushed
System not disabled from previous Remote Start event
Vehicle Alarm system indicator flashing
Ignition in STOP/OFF position
Fuel level meets minimum requirement
All removable doors must not be removed
Malfunction Indicator Light (MIL) not illuminated
REMOTE START CANCEL MESSAGE
I
F EQUIPPED
One of the following messages will display in the
instrument cluster if the vehicle fails to remote start or
exits remote start prematurely:
Remote Start Canceled — Door Open
Remote Start Canceled — Hood Open
Remote Start Canceled — Fuel Low
Remote Start Canceled — Swing Gate Open
Remote Start Canceled — Time Expired
Remote Start Disabled — Start Vehicle To Reset
The message will stay active until the ignition is placed in
the ON/RUN position.
TO ENTER REMOTE START MODE
Push and release the Remote Start button on the key fob
twice within five seconds. The vehicle doors will lock, the
turn signals will flash twice, and the horn will chirp twice.
Then the engine will start, and the vehicle will remain in
the Remote Start mode for a 15 minute cycle.
NOTE:
If an engine fault is present or fuel level is low, the
vehicle will start and then shut down in 10 seconds.
The parking lights will turn on and remain on during
Remote Start mode.
For security, power window operation is disabled when
the vehicle is in the Remote Start mode.
The engine can be started two consecutive times (two
15 minute cycles) with the key fob. However, the igni-
tion must be placed in the ON/RUN position before you
can repeat the start sequence for a third cycle.
TO EXIT REMOTE START MODE
W
ITHOUT DRIVING THE VEHICLE
Push and release the Remote Start button one time or
allow the remote start cycle to complete the entire
15 minute cycle.
NOTE:
To avoid unintentional shutdowns, the system will disable
for two seconds after receiving a valid Remote Start
request.
WARNING!
Do not start or run an engine in a closed garage or
confined area. Exhaust gas contains carbon
monoxide which is odorless and colorless. Carbon
monoxide is poisonous and can cause serious injury
or death when inhaled.
Keep key fobs away from children. Operation of the
Remote Start system, windows, door locks or other
controls could cause serious injury or death.
2
20_JL_OM_EN_USC_t.book Page 15
Loading ...
Loading ...
Loading ...