Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 17
REPLACEMENT KEYS
NOTE:
Only key fobs that are programmed to the vehicle elec-
tronics can be used to start and operate the vehicle. Once
a key fob is programmed to a vehicle, it cannot be
programmed to any other vehicle.
NOTE:
Duplication of key fobs may be performed at an authorized
dealer. This procedure consists of programming a blank
key fob to the vehicle electronics. A blank key fob is one
that has never been programmed.
When having the Sentry Key Immobilizer System serviced,
bring all vehicle keys with you to an authorized dealer.
GENERAL INFORMATION
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Innovation, Science and Economic Development
Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d`Innovation,
Science and Economic Development applicables aux
appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
La operación de este equipo está sujeta a las siguientes
dos condiciones:
1. es posible que este equipo o dispositivo no cause
interferencia perjudicial y
2. este equipo o dispositivo debe aceptar cualquier
interferencia, incluyendo la que pueda causar su
operación no deseada.
NOTE:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
VEHICLE SECURITY ALARM — IF EQUIPPED
The Vehicle Security Alarm monitors the vehicle doors for
unauthorized entry and the ignition switch for
unauthorized operation. When the alarm is activated, the
interior switches for door locks are disabled. The Vehicle
Security Alarm provides both audible and visible signals. If
something triggers the alarm, the Vehicle Security Alarm
will provide the following audible and visible signals:
the horn will pulse, the parking lights and/or turn signals
will flash, and the Vehicle Security Light in the instrument
cluster will flash.
TO ARM THE SYSTEM
Follow these steps to arm the Vehicle Security Alarm:
1. Make sure the vehicle’s ignition is placed in the OFF
position. Refer to "Starting The Engine" in "Starting
And Operating" for further information.
2. Perform one of the following methods to lock the
vehicle:
Push lock on the interior power door lock switch
with the driver and/or passenger door open.
Push the lock button on the exterior Passive Entry
door handle with a valid key fob available in the
same exterior zone. Refer to "Keyless Enter-N-Go —
Passive Entry" in "Doors" in this chapter for further
information.
Push the lock button on the key fob.
3. If any doors are open, close them.
TO DISARM THE SYSTEM
The Vehicle Security Alarm can be disarmed using any of
the following methods:
Push the unlock button on the key fob.
Grasp the Passive Entry Unlock Door Handle (if
equipped). Refer to "Keyless Enter-N-Go — Passive
Entry" in “Doors” in this chapter for further information.
Cycle the vehicle ignition system out of the OFF posi-
tion.
CAUTION!
Always remove the key fobs from the vehicle and lock
all doors when leaving the vehicle unattended.
For vehicles equipped with Keyless Enter-N-Go —
Ignition, always remember to place the ignition in the
OFF position.
2
20_JL_OM_EN_USC_t.book Page 17
Loading ...
Loading ...
Loading ...