Loading ...
Loading ...
Loading ...
82 GETTING TO KNOW YOUR VEHICLE
OPENING THE POWER TOP
Express Mode
Push the open switch and release it within one-half
second. The power top will open automatically to the open
position. This is called “Express Open”. During Express
Open operation, any movement of the switch will stop the
power top.
Manual Mode
To open the power top manually, push and hold the open
switch. The power top will stop automatically at the open
position. Any release of the switch will stop the movement.
The power top will remain in a partially opened position
until the switch is pushed and held again.
CLOSING THE POWER TOP
Express Mode
Push the close switch and release it within one-half
second. The power top will close fully and stop
automatically. This is called “Express Close”. During
Express Close operation, any movement of the switch will
stop the power top.
Manual Mode
To close the power top manually, push and hold the close
switch. The power top will move forward and automatically
stop at the fully closed position. Any release of the switch
will stop the movement. The power top will remain in a
partially closed position until the switch is pushed and
held again.
WIND BUFFETING
Wind buffeting can be described as the perception of
pressure on the ears or a helicopter-type sound in the
ears. Your vehicle may exhibit wind buffeting with the
windows down, or the power top in certain open or partially
open positions. This is a normal occurrence and can be
minimized. If the buffeting occurs with the rear windows
open, then open the front and rear windows together to
minimize the buffeting. If the buffeting occurs with the
power top open, adjust the power top opening to minimize
the buffeting or open any window.
PINCH PROTECT FEATURE
This feature will detect an obstruction in the opening of
the power top during Express Close operation. If an
obstruction in the path of the power top is detected, the
power top will automatically retract. Remove the
obstruction if this occurs. Next, push the close switch and
release to Express Close.
NOTE:
The Power Sliding Top may reverse motion if closing
during a severe headwind. If this occurs, push and hold
the Power Sliding Top switch again to close the top
completely.
If three consecutive power top close attempts result in
Pinch Protect reversals, Pinch Protect will disable and
the power top must be closed in Manual Mode.
POWER TOP MAINTENANCE
Use only a non-abrasive cleaner and a soft cloth to clean
the quarter window glass panel.
Refer to “Bodywork” in Servicing And Maintenance” for
further information. It contains important information on
cleaning and caring for your vehicle.
IGNITION OFF OPERATION
The power top switch can remain active in Accessory Delay
for up to approximately 10 minutes after the vehicle’s
ignition is placed to the Off position. Opening either front
door will cancel this feature.
NOTE:
Ignition Off time is programmable through the Uconnect
System. Refer to “Uconnect Settings/Customer Program-
mable Features” in “Multimedia” for further information.
RELEARN PROCEDURE
For vehicles equipped with a power top, there is a relearn
procedure that allows you to calibrate the power top when
the “Express Mode” stops working. To reset the power top,
follow these steps:
1. Place the ignition in the RUN position, and start the
vehicle.
NOTE:
The engine must be running to perform the relearn
procedure.
WARNING!
There is no anti-pinch protection when the power top is
almost closed. To avoid personal injury be sure to clear
your arms, hands, fingers and all objects from the top’s
path before closing.
20_JL_OM_EN_USC_t.book Page 82
Loading ...
Loading ...
Loading ...