Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 55
10. Secure the wire harness to the body side by plugging
it into the receptacle and reengaging the locking tab.
Securing The Wire Harness
11. Secure the washer hose by snapping it into the top of
the body side receptacle.
Securing The Washer Hose
Secured Wire Harness And Washer Hose
12. Lower the rear window, and close the swing gate.
13. Remove the hard top from the vehicle. Place the hard
top on a soft surface to prevent damage.
REAR HARD TOP INSTALLATION
NOTE:
If the door frames are installed from soft top usage, they
must be removed prior to installation of the hard top.
Refer to “Door Frame” in this section for installation proce-
dures.
1. Inspect the hard top seals for damage and replace if
necessary.
2. Install the hard top using the same steps for removal
in reverse order.
Make sure that the hard top is sitting flush with the
body at the sides and check to ensure that there is a
uniform gap between the lift glass and hard top.
NOTE:
The Torx fasteners that attach the hard top to the body
should be torqued as follows using the provided #50 Torx
head driver and ratchet:
Hard top to B-pillar: 119 in-lb +/- 23 in-lb (13.5 N·m
+/- 2.7 N·m)
Hard top to J-rail: 154 in-lb +/- 30 in-lb (17.5 N·m
+/- 3.5 N·m)
DOOR FRAME
CAUTION!
The removal of the Freedom Top requires four adults
located on each corner. Failure to follow this caution
could damage the Freedom Top.
WARNING!
Do not drive your vehicle on public roads with the
door frame(s) removed as you will lose the protection
that they can provide. This procedure is furnished for
use during off-road operation only.
Do not drive your vehicle on public roads with the
doors removed as you will lose the protection that
they can provide. This procedure is furnished for use
during off-road operation only.
2
20_JL_OM_EN_USC_t.book Page 55
Loading ...
Loading ...
Loading ...