User Manual - Page 13

For 2020 JEEP WRANGLER.

Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 11
KEYS
KEY FOB
Key Fob
Your vehicle uses a keyless ignition system. The ignition
system consists of a key fob with Keyless Enter-N-Go and
a START/STOP push button ignition system. The Remote
Keyless Entry (RKE) system consists of a key fob with a
mechanical key and Keyless Enter-N-Go feature if
equipped.
NOTE:
The key fob may not be detected by the vehicle if it is
located next to a mobile phone, laptop or other electronic
device; these devices may block the key fob’s wireless
signal.
The key fob allows you to lock or unlock the doors and
swing gate from distances up to approximately 66 ft
(20 m). The key fob does not need to be pointed at the
vehicle to activate the system.
NOTE:
With the ignition in ON/RUN position and with the vehicle
doors open, the lock button will be disabled, and only the
unlock button will be enabled. All RKE commands will be
disabled once the vehicle begins moving at 2 mph (4 km/h)
or above.
Backup Mode Starting
In case the ignition switch does not change with the push
of a button, the key fob may have a low or fully depleted
battery. A low key fob battery can be verified by referring to
the instrument cluster, which will display directions to
follow.
NOTE:
A low key fob battery condition may be indicated by a
message in the instrument cluster display, or by the LED
light on the key fob. If the LED key fob light no longer illu-
minates from key fob button pushes, then the key fob
battery requires replacement.
In this situation, a backup method can be used to operate
the ignition switch. Put the nose side of the key fob against
the START/STOP ignition button, and push to operate the
ignition switch.
Backup Starting Method
To Unlock The Doors And Swing Gate
When “1st Press Of Key Fob Unlocks - Driver Door” is
selected within the Uconnect settings, the first push and
release of the key fob unlock button will unlock the driver's
door only, and a second time will unlock all the doors and
swing gate. When the key fob unlock button is pushed, the
Illuminated Entry will initiate, and the turn signal lights will
flash twice. Refer to “Uconnect Settings” in “Multimedia”
for further information.
1 — Mechanical Key Release Button
2 — Unlock Button
3 — Lock Button
4 — Remote Start Button
5 — Panic Button
WARNING!
Push the Mechanical Key Release Button only with the
key fob facing away from your body, especially your eyes
and objects that may be damaged, such as clothing.
CAUTION!
The electrical components inside of the key fob may be
damaged if the key fob is subjected to strong electrical
shocks. In order to ensure complete efficiency of the
electronic devices inside of the key fob, avoid exposing
the key fob to direct sunlight.
2
20_JL_OM_EN_USC_t.book Page 11
Loading ...
Loading ...
Loading ...