Loading ...
Loading ...
Loading ...
12 GETTING TO KNOW YOUR VEHICLE
To Lock The Doors And Swing Gate
Push and release the lock button on the key fob to lock all
doors. The turn signals will flash, and the horn will chirp
once to acknowledge the lock signal.
Key Fob Battery Replacement
NOTE:
When a key fob battery is low, a warning will be indicated
on the vehicle’s instrument cluster, and the key fob LED
will no longer illuminate with a button press.
The recommended replacement battery is CR2450.
NOTE:
Perchlorate Material – special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate .
1. Remove the back cover of the key fob by inserting a
flat-head screwdriver into the slot on the bottom of
the fob. Pry until the cover unsnaps being careful not
to damage the seal. Proceed counterclockwise to
pry the remaining snaps until the battery cover can
be removed.
1-3 – Back Cover Pry Points
2. Remove the depleted battery by inserting a small
flat-head screwdriver into the battery removal slot
and sliding the battery forward and up being careful
not to damage the electronic board underneath.
Battery Replacement
3. Install the new battery into the key fob, making sure
the positive (+) side is facing up. Slide the battery
until it is seated securely below the tabs.
4. Reassemble the back cover making sure it is properly
aligned before snapping it back in place.
Programming Additional Key Fobs
Programming the key fob may be performed by an
authorized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it cannot be
repurposed and reprogrammed to another vehicle.
Request For Additional Key Fobs
NOTE:
Only key fobs that are programmed to the vehicle elec-
tronics can be used to start and operate the vehicle. Once
a key fob is programmed to a vehicle, it cannot be
programmed to any other vehicle.
Duplication of key fobs may be performed at an authorized
dealer. This procedure consists of programming a blank
key fob to the vehicle electronics. A blank key fob is one
that has never been programmed.
NOTE:
When having the Sentry Key Immobilizer System
serviced, bring all vehicle keys with you to an autho-
rized dealer.
Keys must be ordered to the correct key cut to match
the vehicle locks.
WARNING!
Always remove the key fobs from the vehicle and lock
all doors when leaving the vehicle unattended.
Always remember to place the ignition in the OFF
mode.
20_JL_OM_EN_USC_t.book Page 12
Loading ...
Loading ...
Loading ...