Loading ...
Loading ...
Loading ...
228 IN CASE OF EMERGENCY
JACKING AND TIRE CHANGING
JACK LOCATION
The jack and lug wrench are located in the rear cargo area.
To remove jack and tools proceed as follows:
1. Lift the load floor in the cargo area.
Load Floor
NOTE:
The load floor can be removed for easier access by pulling
the load floor directly rearward.
2. Remove the hardware storage cover by pinching the
latch on the left side and pulling upward.
Hardware Storage Cover Latch
3. Turn the plastic wing nut counterclockwise to loosen
the jack from the storage bin.
Plastic Wing Nut Location
4. Remove tool kit and assemble tools.
SPARE TIRE REMOVAL
1. To remove the spare tire from the carrier, remove
the tire cover, if equipped.
2. Remove the Rear Camera Cover by turning the lock
bolt counterclockwise with the #T40 Torx head driver
and ratchet from the supplied tool kit.
Unlock Rear Camera Cover
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the
road to avoid the danger of being hit when operating
the jack or changing the wheel.
Being under a jacked-up vehicle is dangerous. The
vehicle could slip off the jack and fall on you. You
could be crushed. Never put any part of your body
under a vehicle that is on a jack. If you need to get
under a raised vehicle, take it to a service center
where it can be raised on a lift.
Never start or run the engine while the vehicle is on
a jack.
The jack is designed to be used as a tool for changing
tires only. The jack should not be used to lift the
vehicle for service purposes. The vehicle should be
jacked on a firm level surface only. Avoid ice or slip-
pery areas.
20_JL_OM_EN_USC_t.book Page 228
Loading ...
Loading ...
Loading ...