Loading ...
Loading ...
Loading ...
58 GETTING TO KNOW YOUR VEHICLE
6. Swing the frame bracket around the side of the rail,
and insert the screws from underneath. Tighten with
#40 Torx head driver until they are snug, being
careful not to cross-thread the screws or overtighten.
Refer to the table above for the appropriate torque
specifications for the door rail screws.
Step Six
DOOR FRAME INSTALLATION TWO DOOR
M
ODELS — IF EQUIPPED
1. Carefully place the front door rail in the rubber seal
at the top of the windshield, and line up the holes for
the Torx head screws (two for each door).
2. Swing the frame bracket around the side of the rail,
and insert the screws from underneath. Tighten with
#40 Torx head driver until they are snug, being
careful not to cross-thread the screws or overtighten.
Refer to the table below for the appropriate torque
specifications for the door rail screws.
Step Two
SOFT TOP TWO DOOR MODELS —
IF EQUIPPED
Torque
Specification For
Torx Screws
Maximum Minimum
8.8 ft-lbs 11.0 ft-lbs 3.6 ft-lbs
12 N·m 15 N·m 5 N·m
CAUTION!
Do not overtighten the screws. You can strip the screws
if they are overtightened.
WARNING!
The fabric quarter windows and fabric top are
designed only for protection against the elements.
Do not rely on them to contain occupants within the
vehicle or to protect against injury during an acci-
dent. Remember, always wear seat belts.
Make sure hands and fingers are clear of all pinch
points when installing and removing the soft tops.
The lift assist mechanism and side bows may cause
serious injury if fingers or hands get caught in
between.
20_JL_OM_EN_USC_t.book Page 58
Loading ...
Loading ...
Loading ...