Loading ...
Loading ...
Loading ...
40 GETTING TO KNOW YOUR VEHICLE
To adjust the seal compression, proceed as
follows:
1. Open the door and lift the upper half-door up
and away from the lower half. Lay the upper
half-door on a clean, dry surface.
2. Using an 8 mm open-end wrench (not
provided), loosen the nut located inside the
bottom of the upper half-door post, closest to
where the “paper test” detected a gap.
Nut Location Inside Bottom Of Post
3. Using a 3 mm Allen wrench (not provided),
rotate the screw on the side of the post
counterclockwise (while holding the wrench on
the loosened bolt) to increase the seal
compression. If needed, rotate clockwise to
reduce seal compression.
Rotate Screw For Seal Compression
4. Tighten the nut inside the bottom of the post
using the wrench and make sure the screw
head is flush to the post. Reinstall the upper
half-door.
Screw Head Flush To Post
5. Close the door and repeat the “paper test”.
Repeat the adjustment procedure if needed.
1 — 3 mm Allen Wrench
2 — 8 mm Open-End Wrench
22_JL_OM_EN_USC_t.book Page 40
Loading ...
Loading ...
Loading ...