Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 31
7. With the door in the open position, remove the
check bolt from the door check attachment on
the bodyside (using a #T40 Torx head driver).
Door Check (Detached)
8. With the door open, lift the door with the help
of another person, to clear the hinge pins from
their hinges and remove the door.
To Install The Front Doors
1. Locate the upper and lower hinge pins on the
door, and lower them into the body hinges on
the vehicle.
NOTE:
The upper hinge pin is longer, which can be used to
assist in guiding the door into place during instal-
lation.
Hinge Pin Locations
2. With the door in the open position, align the
door check bracket with the hole on the
bodyside. Insert the check screw and tighten
using a #40 Torx head driver to 19.9 ft· lb
(27.0 N·m).
3. Insert the upper and lower hinge pin screws
into the body hinges. Tighten the screws using
a #T50 Torx head driver to 3.8 ft· lb / 5.2 N·m.
Replacing The Wiring Connector Into The Wiring
Harness
To reinstall the wiring connector on the vehicle’s
door into the harness just inside the vehicle,
proceed as follows:
NOTE:
Make sure there is plenty of slack on the wiring
connector during installation. Close the door
slightly to provide more slack if needed.
CAUTION!
Do not close the door before reattaching the
door check to the body. Damage may occur to
the door check.
Do not overtighten Torx fasteners, damage to
the vehicle’s parts will occur.
Hinge pins can break if overtightened during
door install (Max Torque: 6.0 ft· lb/8.1 N·m).
2
22_JL_OM_EN_USC_t.book Page 31
Loading ...
Loading ...
Loading ...