Loading ...
Loading ...
Loading ...
36 GETTING TO KNOW YOUR VEHICLE
(Continued)
9. Repeat the steps on the other side of the
vehicle.
NOTE:
If this kit is being installed with the optional lamp
bracket, the bracket bushing from step 4 is not
needed. Use the spacer from the lamp bracket.
HALF-DOOR INSTALLATION —
I
F EQUIPPED
If applicable, refer to the “Hybrid Supplement” for
additional information.
Use this QR code to access your
digital experience.
This vehicle may be equipped with
half-doors. To install the
half-doors in the vehicle, follow
the instruction sheet packaged in
the box the doors were received
in. Replacement parts may be purchased through
Mopar® Service.
To install the front or rear half-doors, proceed as
follows:
1. Remove the full doors from the vehicle. For
front door removal, see
Ú
page 29
. For rear
door removal, see Ú
page 32.
2. Locate the upper and lower hinge pins on the
lower half-door, and lower them into the body
hinges on the vehicle.
NOTE:
The upper hinge pin is longer, which can be used to
assist in guiding the door into place during instal-
lation.
Lower Half-Door Hinge Pins
3. Insert the upper and lower hinge pin screws
into the body hinges. Tighten the screws using
a #T50 Torx head driver to 3.8 ft· lb / 5.2 N·m.
CAUTION!
Do not run half-doors through an automatic
car wash. This may result in scratches and
wax buildup on the windows.
Careless handling and storage of the
half-doors may damage the seals resulting in
water leaks into the interior of the vehicle.
The upper half-doors must be positioned prop-
erly to ensure sealing. Improper installation
can cause water leaks into the interior of the
vehicle.
Store the zipper pulls of the upper half-door
windows at the upper B-pillar area for both
front and rear doors to avoid damage to the
windows when not in use.
Do not attempt to operate the half-door zipper
in temperatures of 41°F (5°C) or below.
Damage to the window may occur.
CAUTION!
CAUTION!
Do not close the door before reattaching the
door check to the body. Damage may occur to
the door check.
Do not overtighten Torx fasteners, damage to
the vehicle’s parts will occur.
Hinge pins can break if overtightened during
door install (Max Torque: 6.0 ft· lb/8.1 N·m).
22_JL_OM_EN_USC_t.book Page 36
Loading ...
Loading ...
Loading ...