Loading ...
Loading ...
Loading ...
376 SERVICING AND MAINTENANCE
TRANSFER CASE
Fluid Level Check
The fluid level should be to the bottom edge of the
fill hole when the vehicle is in a level position.
Transfer Case
Drain And Refill
For the proper maintenance intervals Ú page 348.
Selection Of Lubricant
Use only the manufacturer recommended fluid
Ú page 426.
MANUAL TRANSMISSION — IF EQUIPPED
Fluid Level Check
Check the fluid level by removing the fill plug. The
fluid level should be between the bottom of the fill
hole and a point not more than 3/16 of an inch
(4.76 mm) below the bottom of the hole.
Add fluid, if necessary, to maintain the proper
level.
Frequency Of Fluid Change
Under normal operating conditions, the fluid
installed at the factory will give satisfactory
lubrication for the life of the vehicle. If the fluid
becomes contaminated with water, it should be
changed immediately. Otherwise, change the fluid
as recommended in the Maintenance Plan. Refer
to the Maintenance Plan for the proper
maintenance intervals Ú page 348.
Selection Of Lubricant
Use only the manufacturer recommended manual
transmission fluid Ú page 426.
AUTOMATIC TRANSMISSION —
I
F EQUIPPED
Special Additives
It is strongly recommended against using any
special additives in the transmission. Automatic
Transmission Fluid (ATF) is an engineered product
and its performance may be impaired by
supplemental additives. Therefore, do not add any
fluid additives to the transmission. Avoid using
transmission sealers as they may adversely affect
seals.
1 — Fill hole
2 — Drain hole
CAUTION!
Do not use chemical flushes in your
transmission as the chemicals can damage your
transmission components. Such damage is not
covered by the New Vehicle Limited Warranty.
22_JL_OM_EN_USC_t.book Page 376
Loading ...
Loading ...
Loading ...