Loading ...
Loading ...
Loading ...
112 GETTING TO KNOW YOUR VEHICLE
RAISING THE WINDSHIELD
1. Release the strap that secured the windshield
in the lowered position.
2. Raise the windshield.
3. Using the provided #40 Torx head driver,
reinstall the four Torx screws located along the
interior of the windshield. Secure them until
they are snug, being careful not to
cross-thread the screws or overtighten.
Interior Torx Screw Locations
4. Reinstall the windshield wiper arms using the
provided 15 mm socket. First, align the tips of
the blade to the “T” mark in the glass. Then,
while holding the arm in that position, reinstall
the hex nut and tighten until snug. Be careful
not to overtighten. Repeat for the other arm.
5. Reinstall the protective caps over the wiper
arm hex bolts and push gently until they snap
into place.
Step Five
6. After completing the steps above:
If your vehicle is equipped with a Soft Top,
reinstall the Door Rails and raise the top.
If your vehicle is equipped with a Hard Top,
reinstall the Freedom Panels.
HOOD
OPENING THE HOOD
If applicable, refer to the “Hybrid Supplement” for
additional information.
Release both of the outside hood latches.
Raise the hood slightly, and place a hand
palm-side down in the center of the hood opening.
Locate the safety latch in the middle, and push the
latch to the right to open.
Place Hand In Hood Opening
1 — Outside Torx Screws
2 — Inside Torx Screws
1 — Hex Bolt Cover Installed
2 — Hex Bolt Cover Removed
22_JL_OM_EN_USC_t.book Page 112
Loading ...
Loading ...
Loading ...