Loading ...
Loading ...
Loading ...
SERVICING AND MAINTENANCE 389
Bulb Replacement
NOTE:
Lens fogging can occur under certain atmospheric
conditions. This will usually clear as atmospheric
conditions change to allow the condensation to
change back into a vapor. Turning the lamps on will
usually accelerate the clearing process.
HALOGEN HEADLAMPS — IF EQUIPPED
See the following steps to replace:
1. Open hood and support using prop rod.
2. Remove the front grille. Turn the retainers
along the top a quarter turn counterclockwise
and remove.
3. Pull the bottom of the grille away starting at
one side and working toward the other.
4. Remove the three screws holding the
headlamp to the vehicle.
5. Remove lamp from the vehicle.
6. Remove the lamp from the collar.
7. Grab the bulb and rotate a quarter turn
counterclockwise.
8. Pull the bulb from the housing.
9. Push connector locking tab to the unlock
position.
10. Remove connector from bulb.
11. Push connector onto new bulb base, and push
the connector locking tab to the lock position.
12. Reinstall bulb housing. Rotate the bulb a
quarter turn clockwise.
FRONT PARK/TURN SIGNAL — IF EQUIPPED
See the following steps to replace:
1. Remove the front wheel liner fasteners to
access bulb sockets.
Wheel Liner
2. Turn the socket assembly a quarter turn
counterclockwise and remove from housing.
Pull the bulb straight from the socket to
replace.
LED FRONT SIDE MARKER — IF EQUIPPED
See the following steps to replace:
1. Remove the front wheel liner fasteners to
access side maker screw and electrical
connector.
2. Remove fastening screw in the back of the
front side maker assembly and disconnect
electrical connector.
3. Remove and replace LED front side marker
light assembly.
HALOGEN FRONT FOG LAMP — IF EQUIPPED
See the following steps to replace:
1. Reach under the vehicle to access the back of
the front fog lamp.
2. Disconnect the wire harness connector from
the front fog lamp connector receptacle.
3. Firmly grab the bulb by the two latch features
and squeeze them together to unlock the bulb
from the back of the front fog lamp housing.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If
the bulb comes in contact with any oily surface,
clean the bulb with rubbing alcohol.
8
22_JL_OM_EN_USC_t.book Page 389
Loading ...
Loading ...
Loading ...