Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR INSTRUMENT PANEL 125
Gear Display — If Equipped
Full
Single
Current Gear — If Equipped
On
Off
Odometer — If Equipped
Show
Hide
Defaults (Restores All Settings To Default Settings)
Cancel
Restore
The menu with (show/hide) means user can press
OK button to choose show or hide this menu on the
instrument cluster display.
Phone Call Status
A pop-up message for an incoming call will appear
on any screen within your instrument cluster. The
pop-up message will appear on your screen until it
is cleared out of the call is ignored, answered, or
the calling ends.
NOTE:
The Uconnect Settings can be programmed to turn
the pop-up off. This will not affect the audio menu
or any phone status information Ú page 207.
Any incoming calls, active calls, and outgoing calls
will take the place of your audio information.
A caller’s name will only be displayed if:
A number is associated with the call. The phone
number will be displayed in place of the caller’s
name.
The test/font of the name is not supported by
the instrument cluster. The instrument cluster
will not display anything in place of the name.
The caller’s name exceeds the maximum
number of characters. The last two to three
digits that will fit will be replaced with “...”.
NOTE:
Any audio information will return to the instrument
cluster once the call has ended.
BATTERY SAVER ON/BATTERY SAVER
M
ODE MESSAGE — ELECTRICAL LOAD
R
EDUCTION ACTIONS — IF EQUIPPED
This vehicle is equipped with an Intelligent Battery
Sensor (IBS) to perform additional monitoring of
the electrical system and status of the vehicle
battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions will
take place to extend the driving time and distance
of the vehicle. This is done by reducing power to or
turning off non-essential electrical loads.
Load reduction is only active when the engine is
running. It will display a message if there is a risk
of battery depletion to the point where the vehicle
may stall due to lack of electrical supply, or will not
restart after the current drive cycle.
When load reduction is activated, the message
“Battery Saver On” or “Battery Saver Mode” will
appear in the instrument cluster display.
These messages indicate the vehicle battery has a
low state of charge and continues to lose electrical
charge at a rate that the charging system cannot
sustain.
Favorite Menus
Speedometer Stop/Start Vehicle Info
Off Road – If
Equipped
(show/hide)
Messages
Driver Assist –
If Equipped
(show/hide)
Fuel Economy
(show/hide)
Settings
Trip Info
(Show/Hide)
Audio (show/
hide)
Screen Setup
3
22_JL_OM_EN_USC_t.book Page 125
Loading ...
Loading ...
Loading ...