Loading ...
Loading ...
Loading ...
390 SERVICING AND MAINTENANCE
4. Pull the bulb straight out from the keyed
opening in the housing and then connect the
replacement bulb.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they
are replaced as an assembly.
REAR TAIL, STOP, TURN SIGNAL, AND BACKUP
LAMP — IF EQUIPPED
See the following steps to replace:
1. Remove interior trim panel cap to access
single retaining screw for tail lamp assembly.
Trim Cap
2. Remove retaining screw and disconnect
electrical connector, then remove tail lamp
assembly from the vehicle.
NOTE:
If necessary, push in on the assembly tab located
inboard behind the lamp housing.
Retaining Screw
3. Remove the three screws from assembly
bracket to access bulb sockets.
Assembly Bracket
4. Rotate the appropriate socket a quarter turn
counterclockwise, then remove it from the
housing.
5. Pull the bulb straight from the socket to
replace.
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) — IF EQUIPPED
The stop lamp is mounted on a bracket that
extends upward from the swing gate behind the
spare tire. If service is needed, obtain the LED
Assembly from an authorized dealer.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If
the bulb comes in contact with any oily surface,
clean the bulb with rubbing alcohol.
22_JL_OM_EN_USC_t.book Page 390
Loading ...
Loading ...
Loading ...