Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 99
11. Secure the washer hose by snapping it into the
top of the body side receptacle.
Step Eleven
Step Eleven
12. Lower the rear window, and close the swing
gate.
13. Remove the hard top from the vehicle. Place
the hard top on a soft surface to prevent
damage.
INSTALLING THE HARD TOP
If the door frames are installed from soft top
usage, they must be removed prior to installation
of the hard top. For removal procedures, see
Ú page 106.
To install the hard top, place the hard top on the
vehicle while making sure that the top is sitting
flush with the body at the sides and check to
ensure that there is a uniform gap between the lift
glass and hard top. Then follow the removal steps
in reverse order.
NOTE:
Inspect the hard top seals for damage and
replace if necessary.
The Torx fasteners that attach the hard top to
the body should be torqued as follows using the
provided #50 Torx head driver and ratchet:
Hard top to B-pillar: 119 in-lb +/- 23 in-lb
(13.5 N·m +/- 2.7 N·m)
Hard top to J-rail: 154 in-lb +/- 30 in-lb
(17.5 N·m +/- 3.5 N·m)
SUNRIDER ® FOR HARD TOP
The Sunrider® soft top can be used in place of the
Hard Top Freedom Panels for quick and easy
opening of the area above the driver and front
passenger seats.
CAUTION!
The removal of the rear Hard Top requires four
adults, one located on each corner. Failure to
follow this caution could damage the Hard Top.
WARNING!
Do not open or close the Sunrider® top while
driving. Operating the top while driving could
cause the driver to lose control of the vehicle.
Failure to follow this warning may result in
serious injury or death.
2
22_JL_OM_EN_USC_t.book Page 99
Loading ...
Loading ...
Loading ...