Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 109
6. Swing the frame bracket around the side of the
rail, and insert the screws from underneath.
Tighten with #40 Torx head driver until they
are snug, being careful not to cross-thread the
screws or overtighten. Refer to the previous
table for the appropriate torque specifications
for the door rail screws.
Step Six
DOOR FRAME INSTALLATION TWO DOOR
M
ODELS — IF EQUIPPED
1. Carefully place the front door rail in the rubber
seal at the top of the windshield, and line up
the holes for the Torx head screws (two for
each door).
2. Swing the frame bracket around the side of the
rail, and insert the screws from underneath.
Tighten with #40 Torx head driver until they
are snug, being careful not to cross-thread the
screws or overtighten. Refer to the following
table for the appropriate torque specifications
for the door rail screws.
Step Two
FOLDING WINDSHIELD
The fold-down windshield on your vehicle is a
structural element that can provide some
protection in some accidents. The windshield also
provides some protection against weather, road
debris and intrusion of small branches and other
objects.
Do not drive your vehicle on-road with the
windshield down, as you lose the protection this
structural element can provide.
If required for certain off-road uses, the windshield
can be folded down. However, the protection
afforded by the windshield is then lost. If you fold
down the windshield, drive slowly and cautiously. It
is recommended that the speed of the vehicle be
limited to 10 mph (16 km/h), with low range
operation preferred if you are driving off-road with
the windshield folded down.
Raise the windshield as soon as the task that
required its removal is completed and before you
return to on-road driving. Both you and your
Target Torque
Specification
For Torx
Fasteners
Maximum Minimum
79.6 in-lb
(9 N·m)
87.6 in-lb
(9.9 N·m)
71.7 in-lb
(8.1 N·m)
CAUTION!
Do not overtighten the screws. You can strip the
screws if they are overtightened.
CAUTION!
Lowering of the windshield is NOT
recommended in vehicles equipped with a
Power Sliding Top. Damage will occur to the top
as well as the header seal.
2
22_JL_OM_EN_USC_t.book Page 109
Loading ...
Loading ...
Loading ...