Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 71
Door Frame Removal
NOTE:
In four door models, the rear door frames must
be removed first, followed by the front door
frames.
1. Using the provided #40 Torx head driver
and ratchet, loosen the Torx screws
located on the underside of each door
frame (two per door).
Door Frame Screw Locations
2. Once all the way loosened, remove the
screws by pulling downward.
NOTE:
Screws will not fall out once completely loose,
as they are held in place by an internal mecha-
nism.
Remove Screws From Below Frame
3. Lift the frame upward, removing it from the
vehicle.
Step Three
4. Store screws in a secure location.
5. Repeat procedure on the front door frame
(four door models).
Door Frame Installation Four Door Models —
If Equipped
1. Install the front door rail first.
2. Carefully place the front door rail in the
rubber seal at the top of the windshield, and
line up the holes for the Torx head screws
(two for each door).
WARNING!
Do not drive your vehicle on public roads
with the door frame(s) removed as you will
lose the protection that they can provide.
This procedure is furnished for use during
off-road operation only.
Do not drive your vehicle on public roads
with the doors removed as you will lose the
protection that they can provide. This
procedure is furnished for use during
off-road operation only.
2
20_JL_OM_EN_USC_t.book Page 71
Loading ...
Loading ...
Loading ...