Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 283
4. Rotate the appropriate socket a quarter
turn counterclockwise, then remove it from
the housing.
5. Pull the bulb straight from the socket to
replace.
Center High Mounted Stop Lamp (CHMSL)
The stop lamp is mounted on a bracket that
extends upward from the swing gate behind the
spare tire. If service is needed, obtain the LED
Assembly from an authorized dealer.
1. Remove the spare tire.
2. Remove the screws holding the tire carrier
cover.
3. Remove two screws from lamp assembly
and disconnect electrical connector.
License Plate Lamps
See an authorized dealer to replace these LED
assemblies.
FUSES
General Information
The fuses protect electrical systems against
excessive current.
When a device does not work, you must check
the fuse element inside the blade fuse for a
break/melt.
Also, please be aware that when using power
outlets for extended periods of time with the
engine off may result in vehicle battery
discharge.
Blade Fuses
WARNING!
When replacing a blown fuse, always use
an appropriate replacement fuse with the
same amp rating as the original fuse. Never
replace a fuse with another fuse of higher
amp rating. Never replace a blown fuse with
metal wires or any other material. Failure to
use proper fuses may result in serious
personal injury, fire and/or property
damage.
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an
authorized dealer.
If a general protection fuse for safety
systems (air bag system, braking system),
power unit systems (engine system,
gearbox system) or steering system blows,
contact an authorized dealer.
1 — Fuse Element
2 — Blade Fuse with a good/functional fuse ele-
ment.
3 — Blade fuse with a bad/not functional fuse el-
ement (blown fuse).
6
20_JL_OM_EN_USC_t.book Page 283
Loading ...
Loading ...
Loading ...