Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 63
7. Using the provided #50 Torx head driver
and ratchet, unscrew the Torx screw on both
rear corners of the vehicle, removing the
retainers.
Remove Rear Retainers
Installing The Soft Top — Four Door Models
NOTE:
The following procedures are for first time set
up only. For future soft top procedures, refer to
“Soft Top” in this section.
1. Locate and remove the following items
prior to hard top removal:
Right and left side door rails
Eight door frame attachment Torx head
screws
Right and left side quarter windows
Rear window
Swing gate bar
2. Remove the hard top. Refer to “Rear Hard
Top Removal” in this section.
3. Install the door rails, starting with the front,
followed by the rear on each side. Refer to
“Door Frame Installation — Four Door
Models” in this section for instructions and
appropriate torque specifications for the
door rail Torx screws.
4. Install the rear retainers on each side of the
rear of the vehicle using the provided
#50 Torx head driver and ratchet. Refer to
the table below for recommended torque
specifications.
Installing Rear Retainers
CAUTION!
Do not over tighten Torx screws. Damage to
the retainers will occur.
Torque
Specification
For Torx
Screw
Maximum Minimum
119.5 in-lbs 150.5 in-lbs 106.2 in-lbs
13.5 N·m 17.0 N·m 12.0 N·m
2
20_JL_OM_EN_USC_t.book Page 63
Loading ...
Loading ...
Loading ...