Loading ...
Loading ...
Loading ...
282 IN CASE OF EMERGENCY
3. Remove and replace LED front side marker
light assembly.
Halogen Front Fog Lamp
1. Reach under the vehicle to access the
back of the front fog lamp.
2. Disconnect the wire harness connector
from the front fog lamp connector recep-
tacle.
3. Firmly grasp the bulb by the two latch
features and squeeze them together to
unlock the bulb from the back of the front
fog lamp housing.
4. Pull the bulb straight out from the keyed
opening in the housing and then connect
the replacement bulb.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps
they are replaced as an assembly.
Rear Tail, Stop, Turn Signal, And Backup
Lamp
1. Remove interior trim panel cap to access
single retaining screw for tail lamp
assembly.
Trim Cap
2. Remove retaining screw and disconnect
electrical connector, then remove tail lamp
assembly from the vehicle.
NOTE:
If necessary, push in on the assembly tab
located inboard behind the lamp housing.
Retaining Screw
3. Remove the three screws from assembly
bracket to access bulb sockets.
Assembly Bracket
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
20_JL_OM_EN_USC_t.book Page 282
Loading ...
Loading ...
Loading ...