Loading ...
Loading ...
Loading ...
108 GETTING TO KNOW YOUR VEHICLE
NOTE:
Be sure to remove the cover before returning
the windshield to the normal position. Store the
cover in the cargo area.
Cleaning Instructions
During windshield down applications, dust/dirt
can accumulate in the cover and block the
camera lens. Use a microfiber cloth to clean the
camera lens, module, and inside cover, being
careful not to damage or scratch the module.
Raising The Windshield
1. Release the strap that secured the wind-
shield in the lowered position.
2. Raise the windshield.
3. Using the provided #40 Torx head driver,
reinstall the four Torx screws located along
the interior of the windshield. Secure them
until they are snug, being careful not to
cross-thread the screws or overtighten.
Interior Torx Screw Locations
4. Reinstall the windshield wiper arms using
the provided 15 mm socket. First, align the
tips of the blade to the “T” mark in the glass.
Then, while holding the arm in that position,
reinstall the hex nut and tighten until snug.
Be careful not to over-tighten. Repeat for
the other arm.
5. Replace the protective caps over the wiper
arm hex bolts and push gently until they
snap into place.
Protective Cap Over Wiper Bolt
6. After completing the steps above:
If your vehicle is equipped with a Soft
Top, reinstall the Door Rails and raise the
top.
If your vehicle is equipped with a Hard
Top, reinstall the Freedom Panels.
20_JL_OM_EN_USC_t.book Page 108
Loading ...
Loading ...
Loading ...