Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 239
To Cancel
The following conditions cancel the system:
The brake pedal is applied
The CANC button is pushed
An Anti-Lock Brake System (ABS) event
occurs
The gear selector is removed from the DRIVE
(D) position
The Electronic Stability Control/Traction
Control System (ESC/TCS) activates
The vehicle parking brake is applied
Driver seatbelt is unbuckled at low speeds
Driver door is opened at low speeds
The braking temperature exceeds normal
range (overheated)
A Trailer Sway Control (TSC) event occurs
The vehicle speed is less than 15 mph
(24 km/h) (manual transmission only)
The clutch is depressed for more than 10
seconds (manual transmission only)
The vehicle is placed in NEUTRAL for more
than 10 seconds (manual transmission only)
The driver shifts to 1st gear (manual trans-
mission only)
To Turn Off
The system will turn off and clear the set speed
in memory if:
The Adaptive Cruise Control (ACC) on/off
button is pushed
The Normal (Fixed Speed) Cruise Control on/
off button is pushed
The ignition is placed in the OFF position
You switch to Four-Wheel Drive Low
To Resume
If there is a set speed in memory push the RES
(resume) button and then remove your foot
from the accelerator pedal. The instrument
cluster display will display the last set speed.
NOTE:
If your vehicle stays at standstill for longer
than two seconds, then the system will
cancel and the brake force will be
ramped-out. The driver will have to apply the
brakes to keep the vehicle at a standstill.
ACC cannot be resumed if there is a
stationary vehicle in-front of your vehicle in
close proximity.
To Vary The Speed Setting
To Increase Speed
While ACC is set, you can increase the set speed
by pushing the SET (+) button.
The driver's preferred units can be selected
through the instrument panel settings. Refer to
“Getting To Know Your Instrument Panel” for
more information. The speed increment shown
is dependent on the chosen speed unit of
US (mph) or Metric (km/h):
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
5
20_JL_OM_EN_USC_t.book Page 239
Loading ...
Loading ...
Loading ...