Loading ...
Loading ...
Loading ...
254 STARTING AND OPERATING
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you
to see an on-screen image of the rear surround-
ings of your vehicle whenever the gear selector
is put into REVERSE (R). The image will be
displayed in the touchscreen display along with
a caution note to “check entire surroundings”
across the top of the screen. After five seconds
this note will disappear. The ParkView camera is
located on the rear of the vehicle in the center
of the spare tire.
Manual Activation Of The Rear View Camera
1. Press the “Controls” button located on the
bottom of the Uconnect display.
2. Press the “Backup Camera” button to turn
the Rear View Camera system on.
When the vehicle is shifted out of REVERSE
(with Camera delay turned off), the rear Camera
mode is exited and the previous screen appears
again.
When the vehicle is shifted out of REVERSE
(with Camera delay turned on), the rear Camera
image will be displayed for up to 10 seconds
unless the vehicle speed exceeds 8 mph
(13 km/h), the transmission is shifted into
PARK, the ignition is placed in the OFF position,
or the touchscreen button “X” to disable display
of the Rear View Camera image is pressed.
Whenever the Rear View Camera image is acti-
vated through the “Backup Camera” button in
the “Controls” menu, and the vehicle speed is
greater than, or equal to, 8 mph (13 km/h), a
display timer for the image is initiated. The
image will continue to be displayed until the
display timer exceeds 10 seconds.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image will
be displayed continuously until deactivated
via the touchscreen button “X”, the transmis-
sion is shifted into PARK, or the ignition is
placed in the OFF position.
The touchscreen button “X” to disable display
of the camera image is made available ONLY
when the vehicle is not in REVERSE.
When enabled, active guide lines are overlaid
on the image to illustrate the width of the
vehicle and its projected backup path based on
the steering wheel position. A dashed center
line overlay indicates the center of the vehicle to
assist with parking or aligning to a hitch/
receiver.
When enabled, fixed guide lines are overlaid on
the image to illustrate the width of the vehicle.
Different colored zones indicate the distance to
the rear of the vehicle.
The following table shows the approximate
distances for each zone:
The vehicle must be driven slowly when
using ParkSense in order to be able to stop
in time when an obstacle is detected. It is
recommended that the driver looks over
his/her shoulder when using ParkSense.
CAUTION! (Continued)
Zone Distance To The Rear
Of The Vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow 1 ft - 6.5 ft
(30 cm - 2 m)
Green 6.5 ft or greater
(2 m or greater)
20_JL_OM_EN_USC_t.book Page 254
Loading ...
Loading ...
Loading ...