Loading ...
Loading ...
Loading ...
01
Chapter
8
En
costs or expenses arising from data loss
or corruption.
Never insert or eject an SD memory card
while driving.
Handling the USB connector
CAUTION
To prevent data loss and damage to the
storage device, never remove it from this
product while data is being transferred.
Pioneer cannot guarantee compatibility
with all USB mass storage devices and
assumes no responsibility for any loss
of data on media players, iPhone, smart-
phone, or other devices while using this
product.
Failure to operate
After-sales service for Pioneer
products
Please contact the dealer or distributor
from which you purchased the product for
after-sales service (including warranty con-
ditions) or any other information. In case
the necessary information is not available,
please contact the companies listed below.
Please do not ship your product to the
companies at the addresses listed below for
repair without making advance contact.
— U.S.A
Pioneer Electronics (USA) Inc.
CUSTOMER SUPPORT DIVISION
P.O. Box 1760 Long Beach, CA
90801-1760
800-421-1404
— CANADA
Pioneer Electronics of Canada, Inc.
CUSTOMER SATISFACTION
DEPARTMENT
340 Ferrier Street, Unit 2, Markham,
Ontario L3R 2Z5, Canada
1-877-283-5901
905-479-4411
For warranty information, please see the
Limited Warranty sheet included with your
product.
Visit our website
Visit us at the following site:
http://www.pioneerelectronics.com
In Canada
http://www.pioneerelectronics.ca
1 Register your product.
2 Receive updates on the latest products
and technologies.
3 Download owner’s manuals, order prod-
uct catalogs, research new products, and
much more.
4 Receive notices of software upgrades and
software updates.
Protecting the LCD panel and
screen
p Do not expose the LCD screen to direct
sunlight when this product is not
used. This may result in LCD screen
malfunction due to the resulting high
temperatures.
p When using a cellular phone, keep the
antenna of the cellular phone away from
the LCD screen to prevent disruption of
the video in the form of spots, colored
stripes, etc.
p To protect the LCD screen from damage,
be sure to touch the touch panel keys
only with your finger and do so gently.
Notes on internal memory
■ Before removing the vehicle
battery
p Some of the settings and recorded con-
tents will not be reset.
■ Data subject to erasure
The information is erased by disconnecting
the yellow lead from the battery (or removing
the battery itself).
p Some of the settings and recorded con-
tents will not be reset.
■ Resetting the microprocessor
CAUTION
Pressing the RESET button resets set-
tings and recorded contents to the factory
settings.
p Do not perform this operation when a
device is connected to this product.
p Some of the settings and recorded
contents will not be reset.
The microprocessor must be reset under the
following conditions:
Prior to using this product for the first
time after installation.
If this product fails to operate properly.
If there appears to be problems with the
operation of the system.
1 Turn the ignition switch OFF.
2 Press the RESET button with a pen
tip or other pointed implement.
Settings and recorded contents are reset to
the factory settings.
1
1 RESET button
About this manual
This manual uses diagrams of actual
screens to describe operations. However,
the screens on some units may not match
those shown in this manual depending on
the model used.
Use and care of the remote
control
■ Installing the battery
Slide the tray on the back of the remote con-
trol out and insert the battery with the plus
(+) and minus (–) poles aligned properly.
When using for the first time, pull out the
film protruding from the tray.
WARNING
Keep the battery out of the reach of chil-
dren. Should the battery be swallowed,
consult a doctor immediately.
Batteries (battery pack or batteries
installed) must not be exposed to exces-
sive heat such as sunshine, fire or the
like.
CAUTION
Remove the battery if the remote control
is not used for a month or longer.
There is a danger of explosion if the
battery is incorrectly replaced. Replace
only with the same or equivalent type.
Do not handle the battery with metallic
tools.
Do not store the battery with metallic
objects.
If the battery leaks, wipe the remote
control completely clean and install a
new battery.
When disposing of used batteries, com-
ply with governmental regulations or
environmental public institutions’ rules
that apply in your country/area.
“Perchlorate Material – special handling
may apply.
See www.dtsc.ca.gov/hazardouswaste/
perchlorate. (Applicable to California,
U.S.A.)”
■ Using the remote control
Point the remote control in the direction of
the front panel to operate.
The remote control may not function
properly in direct sunlight.
Important
Do not store the remote control in high
temperatures or direct sunlight.
Loading ...
Loading ...
Loading ...