Loading ...
Loading ...
Loading ...
83
-------- Enabled ----------------------------------------------------------------------
Current Enabled = No
Enter Y or N for Enabled
>> y
-------- Auto Probe Detail Menu --------------------------------------------------------
Type : NTP
Name : Probe 5
Description : Cycle Load 5
Primary Address : 10.2.0.2
Primary Port : 123
Secondary Address : 10.2.0.3
Secondary Port : 123
Interval : 45
Retries : 3
Enabled : Yes
1 – Type
2 – Name
3 – Description
4 – Primary Address
5 – Primary Port
6 – Secondary Address
7 – Secondary Port
8 – Interval
9 – Retries
10 – Enabled
A – Apply Changes
D – Delete
X – Auto Probes
M – Return to Main Menu
<ENTER> Refresh Menu
>> a
-------- Auto Probes ----------------------------------------------------------------------
-----------------------------------------------------------------------------------------
# | Name | Type | Primary Address | Interval | Retries | Status
-----------------------------------------------------------------------------------------
1 Ping Watchdog Ping 10.22.0.1 3 5 Okay
2 NTP Watchdog NTP 10.22.0.2 15 3 Fault
3 Probe 3 NTP 10.22.0.5 3 5 InitFl
4 Probe 4 NTP 10.22.0.6 15 4 Okay
5 Probe 5 Ping 10.10.10.10 5 8 Unk
#- Auto Probe
0- Add New Auto Probe
X- Remote Services
M- Return to Main Menu
<ENTER> Refresh Menu
>>
The Status column will display one of the following states:
Off - the probe is disabled
Okay – a connection has been established and the probe is active
Fault – a connection had been established but subsequently failed
InitFl – initial connection failed.
Unk – Unknown state. This occurs when an initial connection has not yet been established, i.e. after a reboot, when a new probe is enabled, and
when a previously disabled probe is re-enabled.
4. Telnet/SSH Console
Loading ...
Loading ...
Loading ...