Loading ...
Loading ...
Loading ...
33
4. Telnet/SSH Console
4.1.2 Identification
This is the section of the device menus that will contain the information about the device. This information will be both user-defined settings, such
as device name or location, and equipment-specific information like vendor, product and protocol. There are data items on this menu which will be
displayed for all devices and some data displayed based upon the type and protocol for the device. Any data that is modifiable by the user will have
a prompt option displayed on the menu.
Device Identification Menu
-------- Identification --------------------------------------------------------
Device Name : Device0001
Location :
Region :
Vendor : TRIPPLITE
Product : SMART750RM1UN
Protocol : 3003
Date Installed : 2016-04-08
State : NORMAL
Type : UPS
Port Mode : RS232
Port Name : /dev/ttyO2
VA Rating : 750 VA
Firmware Version : 2264 (Rev A)
Serial Number :
Watchdog Supported : Yes
Nominal Battery Voltage : 24 V
Input Line Count : 1
Nominal Input Voltage : 120 V
Nominal Input Frequency : 60 Hz
Load Banks Total : 3
Load Banks Controllable : 2
Device ID : 1
1- Name
2- Location
3- Region
4- Date Installed
5- Serial Number
6- Device ID
X- Device Main Menu
M- Return to Main Menu
<ENTER> Refresh Menu
Menu Data
The following menu data should display for all devices:
Device Name
This is the user-modifiable device name. The system will give the device
a default name. The default for a UPS, PDU or ATS is “DeviceX”, where
X is the last four digits of the device’s serial number. For devices that do
not have a serial number, “X” will default to “001.” The default for an
EnviroSense2 module is “Sensor.” The default for SRCOOLNET is “AC.”
Location
The user-defined device location. There is no default for location.
Region
The user-defined device region. There is no default for region.
Vendor
This is the manufacturer of the device.
Product
This is the device model.
Protocol
This is the protocol used by the device.
Date Installed
This is the date that the device was installed. For a UPS, this will be
used for the battery-installed date and is therefore modifiable.
State
This is the current operating state of the device. Some valid values are:
• NORMAL
• INFORMATION
• WARNING
• STATUS
• CRITICAL
• OFFLINE
Type
This is the device type. Some valid values are:
• UPS
• PDU
• ENVIROSENSE
• ATS
Loading ...
Loading ...
Loading ...