Loading ...
Loading ...
Loading ...
62
TRANSCEND RAILING
universal rails from underside of railing into bottom of
decking board, with 2 " (51 mm) pan-head screws (not
provided) at an angle every 16 " (406 mm) on center.
IMPORTANT NOTES:
»
If using Select decking, USE maximum length 1-3/4"
(44 mm) screw and NOT 2" (51 mm) screw.
»
Screws that are used for attachment of decking board
to railing MUST be attached at angle to prevent screw
from penetrating through the top of decking board.
11. Slide baluster spacers up
and snap into universal
rails.
NOTE: If necessary, cut
tips off rail gaskets prior to
installation.
12. Use scarf cut for posts where two deck boards meet.
NOTES:
»
If installing in weather below 40°F (4.5°C), leave 1/8 " (3
mm) gap between deck boards.
»
Deck boards can overhang end of last post
maximum 1/2" (13 mm).
11
12
Optional
HOW TO INSTALL COCKTAIL RAILING/CONTINUED
TREX TRANSCEND
1. Installing Pressure-Treated Posts
See instructions on page 59.
2.
Installing Post Sleeve Skirts and Post Sleeves
See instructions on page 59.
3.
Installing Railing Support Brackets (RSBs)
See instructions on page 59.
4.
Cutting Railings
See instructions on page 60.
5.
Attaching Foot Block
See instructions on page 60.
6.
Attaching Bottom Rail (Universal Rail), Adding
Weep Holes
See instructions on page 60.
7-8.
Placing Baluster Spacers and Balusters
See instructions on page 60.
Attaching Inverted Universal Rail as Top Rail
9. Place inverted universal
rail onto RSBs with
balusters in channel.
Attach universal rail
with three self-tapping
screws provided (use
three outer holes; do
not use hole in RSB
that is closest to post).
If two hole bracket is
included, attach with
two self-tapping holes
(provided).
HOW TO INSTALL TRADITIONAL RAILING
TREX TRANSCEND
1
9
x2
2
2
Hole
RSB
2
3
Hole
RSB
Loading ...
Loading ...
Loading ...