Loading ...
Loading ...
Loading ...
105
SIGNATURE RAILING
INSTALLING ALUMINUM GATE
» SEE PAGE 56 FOR SKU NUMBERS
1. Measure opening between posts (gates can be
customized to fi t nearly any opening up to 48"
[1219 mm] wide).
2. Subtract 1-7/8" (48 mm) from above measurement.
This will allow for proper gapping and location
of gate.
3. Identify top and bottom of panel.
NOTE: The posts only fi t in one direction.
4. Lay panel on a fl at non-marring surface. Place
posts on top of panel. Place posts so that width
measurement from Step 2 is to the outside of each
post.
5. Adjust posts so that cut marks do not fall on a
baluster. Make sure distance from fi rst baluster to
post is the same on both sides. Mark cut locations
on panel.
NOTE: If widths do fall on a baluster, cut baluster
fl ush at top and bottom prior to cutting panel.
6. Cut panel using a reciprocating saw (equipped with
a metal blade).
7. Insert posts into panel.
NOTE: Make sure top and bottom of panel
orientation is correct.
1
3
1
1
1
1
1
5
2
4
1
6
7
Loading ...
Loading ...
Loading ...