Loading ...
Loading ...
Loading ...
FLASH MEASURE OF SEPARATE FLASH UNIT
You can measure the effect of an attached ash unit (with PC
connected ash units and SCA3902 compatible ash units
set to M mode), where the camera acts as a ash meter. The
aperture setting can be adjusted and more trial exposures made
until the information on the grip display is satisfactory.
To use ash measure:
1 Assign a button as FLASH button.
2 Press the Assigned button on to access the ash option
screen.
3 Turn the Rear control wheel until Flash measure appears.
4 Make preliminary required aperture setting by turning the
front control wheel.
5 Press the AE-L button. The camera will close the aperture,
raise the mirror and re the ash. Light reected from the
ash lit subject will be reected off a white spot on the
auxiliary shutter to the meter sensor.
6 Deviations from a normal exposure are displayed as
differences in EV on the grip display and the viewnder
display. If ‘High’ or ‘Low’ appears, change the aperture
accordingly and make a new test reading.
Change the aperture until Diff EV: 0 appears, or the desired
amount of deviation from the normal exposure.
Diff EV
Low = more than 2 EV below.
Diff EV
High = more than 2 EV above.
Note!
The ‘Low Flash’ warning can be disabled in Main Menu on the
Sensor Unit Display Settings.
H6D www.hasselblad.com
USER GUIDE
To Use
98
Loading ...
Loading ...
Loading ...