Loading ...
Loading ...
Loading ...
1
2
1
2
Film Loading
The lm magazine can be loaded either on or off the camera.
Regularly check the interior of the magazine and remove dust,
particles or any scraps of paper from previous rolls of lm. Load
and unload lm magazines away from direct light sources.
1) Fold out the lm holder key and turn it counter-clockwise
90° A. Withdraw the lm holder completely B.
2) Place an empty take-up spool in the upper spool holder by
placing one end over the xed stud in the holder and the other
end underneath the sprung spool retaining arm. Rotate the
spool a little if necessary until it clicks into position.
3) Completely remove the retaining paper band from a new roll
of lm and place it in the lower spool holder. See diagram for
correct orientation. Ensure you do not place the lm spool the
wrong way around!
4) Pull 8–10 cm (3–4 in.) of paper backing from the lm roll and
insert the tongue of the backing paper into the slot in the take-
up spool. Turn the spool one complete turn to ensure the tongue
is rmly held in place by the overlying paper backing.
5) Re-insert the lm holder into the main body of the lm
magazine ensuring the correct orientation. Press rmly inwards
towards the magazine and pay particular attention to see that
both sides are level with the magazine body A before turning the
lm holder key clockwise 90° to lock the lm holder in place and
fold the key back into its stored position B. You might nd that
increased pressure on the left hand side of the lm holder will
more easily ensure a positive and correct positioning in the
magazine. If the camera is active or in standby mode the lm
will be wound automatically by the camera to position the rst
frame (this function can be changed in ‘Custom options’ so that
the lm is advanced only when the shutter release button is
pressed the rst time).
Beeper
The beeper sounds immediately after last-but-one frame has
been exposed. This function can be turned off in Options.
Film Wind On and Off
Wind on: See ‘Film wind-on’ under Custom Options for a
setting choice. Wind off: When the last frame has been
exposed, the lm will automatically be wound off. However, to
wind off a lm sooner, press the lm wind off button. Use a
ballpoint pen or similar to activate it. You must also conrm the
message on the grip LCD before the lm winds off.
Unloading a lm
Remove the lm holder in the same manner as when loading
a lm. Grip the exposed roll of lm rmly and remove. Ensure
the paper backing is wound tightly and that it is sealed with the
band properly (the band may need to be moistened to activate
the adhesive depending on type). Store exposed lms away from
strong light sources and contact with sharp objects. Move the
remaining empty spool to the take-up spool compartment.
H6D www.hasselblad.com
USER GUIDE
Accessories
185
Loading ...
Loading ...
Loading ...