Loading ...
Loading ...
Loading ...
Film Tab Holder
Holds an ID tab from the lm roll pack as a reminder of the type
of lm loaded. Remember to change it if you change lm type!
Film Holder Key
Secures the lm holder in the magazine. Fold out the key and
turn counter-clockwise 90° to remove the lm holder and turn
clockwise 90° to lock the lm holder in place.
Magazine Settings Lock
All settings can be locked to avoid inadvertent changes. To
change the settings, slide the settings lock (see illustration) to
the right until it stops. After the changes have been made, slide
the settings lock to the left (see symbol on magazine) again to
secure the new settings.
Data bus Interface
Data interface between magazine and camera. Ensure the
contacts are kept clean and protected from damage. Keep
the protective cover on when the magazine is being stored or
transported.
Battery
The magazine uses a battery to retain information and settings
when unattached from the camera. When attached to the
camera body, the magazine takes its power requirements
from the camera batteries. The magazine battery will normally
be effective for 1-2 years depending on use (off camera
illumination, for example). When the battery is in a very low
condition, (approx. 1 month of use left), a low battery symbol
appears on the magazine LCD as a warning. The magazine will
continue to function with no battery power left as long as it
remains attached to the camera body. However, when detached,
the settings will not be stored.
Battery Replacement
Release the lm holder by folding out the lm holder key and
rotating it 90° in a counter-clockwise direction. Withdraw the
lm holder completely. On the bottom plate on the inside of the
lm magazine housing you will nd a slotted circular battery
cover. Insert a small coin or similar into the slot and rotate the
cover about 20° in a counter-clockwise direction. The cover
will be freed and the battery can be removed. Replace with
a fresh CR2032 / 3V lithium (or equivalent) battery. Observe
the polarity and ensure the positive (+) face is uppermost and
replace the cover (ensure the retaining lugs are inserted in the
battery compartment slots), locking it into place by rotating
it in a clockwise direction until it stops. If you inadvertently
insert the battery incorrectly, the lm magazine will not be
damaged though it will not function. Try to avoid touching the
surface of the battery with your bare ngers as sweat residue
can decrease the electrical conductivity of the battery casing
and might cause corrosion. After battery replacement, the
magazine’s parameters return to the default settings (Bar code,
120, Data-on, Count up).
H6D www.hasselblad.com
USER GUIDE
Accessories
181
Loading ...
Loading ...
Loading ...