Loading ...
Loading ...
Loading ...
Table13:OvenTroubleshootingChart
Convection Bake Results are not as Expected
Oven temperature is too hot or too cold
Oven light is not working properly
Oven light will not turn off
Cannot remove lens cover on light
Oven will not Self-Clean properly
Clock and timer are not working properly
Porcelain chips
"F" and a number appears in display and con-
trol beeps
With a new range there is a strong odor when
oven is turned on
Control does not react when the pad is
touched
Fan is running during modes that don't use
convection
Warm air or steam escapes from oven vent
Cooling fan runs after oven is turned off (Slide-
in ranges only)
The cooktop does not operate during Self-
Clean
If the Automatic Convection Conversion Feature is turned off, the temperature must
be manually reduced by 25°F. If the feature is active, the temperature is automati-
cally adjusted. See "Turn Automatic Convection Conversion ON or OFF" on
page 15 for more information. Refer to cooking charts and tips for rack positions,
cooking times and pan selection. Adjust oven calibration if necessary. See"Change
the Oven Temperature Offset" on page 13.
The oven thermostat needs adjustment. See Oven Temperature Offset. See
"Change the Oven Temperature Offset" on page 13.
Replace or reinsert the light bulb if loose or defective. Touching the bulb with fin-
gers may cause the bulb to burn out.
Check for obstruction in oven door. Check to see if hinge is bent. When the
Sabbath feature is activated, the oven light will stay on or off (as selected
during set-up) during the entire Sabbath mode.
There may be soil build-up around the lens cover. Wipe lens cover area
with a clean dry towel prior to attempting to remove the lens cover.
Allow the oven to cool before running Self-Clean. Always wipe out loose soils or
heavy spittovers before running Self-Clean. If oven is badly soiled, set oven for a
five-hour Self-Clean. See Preparing the Oven to Self-Clean.
Make sure there is electrical power to oven. See Clock and Timer sections.
When oven racks are removed and replaced, always tilt racks upward and do not
force them to avoid chipping the porcelain.
This is a fault code. Press Off to clear the display and stop beeping. Reset oven if
necessary. If fault code remains and beep continues, record fault code, cancel oven
and call authorized service technician.
This is normal with a new range and wilt disappear after a few uses. Operating the
self-clean cycle will also "burn-off" the smell more quickly.
Be sure that pad is clean. Touch the center of the touchpad. Use the flat part of your
finger.
On some models, the convection fan will run while the oven is preheating for the
bake mode. This is normal.
Slide-in models also have a cooling fan that runs during every cooking mode.
It is normal to see or feel steam or warm air escaping from the oven vent. Do not
block the vent.
This is normal. When the oven has cooled to a pre-determined temperature, the
cooling fan turns off.
This is normal for some models. Operation will return once Self-Clean is complete.
Warranty
What this Warranty Covers & Who it
Applies to:
The limited warranty provided by BSH Home Appliances in this Statement of Limited Prod-
uct Warranty applies only to the Bosch freestanding and slide-in range, ("Product") sold to
you, the first using purchaser, provided that the Product was purchased: (1) for your nor-
mal, household (non-commercial) use, and has in fact at all times only been used for nor-
mal household purposes; (2) new at retail (not a display, "as is", or previously returned
model), and not for resale, or commercial use; and (3) within the United States or Canada,
and has at all times remained within the country of original purchase. The warranties stated
herein apply only to the first purchaser of the Product and are not transferable. Bosch
reserves the right to request proof of purchase at the time any warranty claim is submitted
to confirm that the Product falls within the scope of this limited product warranty.
English 42
Loading ...
Loading ...
Loading ...