Loading ...
Loading ...
Loading ...
276
Installing the embroidery frame
holder
After embroidering using the cap embroidery
frame is finished, remove the needle plate spacer
and cap frame driver, and then re-attach the
embroidery frame holder.
a
Remove the needle plate spacer.
1 Needle plate spacer
b
Loosen the two lower thumb screws.
1 Thumb screws
c
Remove the two upper thumb screws.
1 Thumb screws
d
Remove the cap frame driver.
e
With the hole on the sweat guard holder
aligned with the centerline of the guiding
plate, insert the two thumb screws removed
in step
c into the holes at the top, and then
tighten the thumb screws.
1 Hole on the sweat guard holder
2 Centerline of guiding plate
3 Holes on the top
• Insert the thumb screws into the holes where the cap
frame driver that was originally installed (holes that
the thumb screws were removed from in step
b on
page 265).
→ The movable section of the cap frame driver is
secured.
Note
• Be careful that the cap frame driver does
not hit any nearby parts, such as the
presser foot.
Loading ...
Loading ...
Loading ...