Loading ...
Loading ...
Loading ...
116
If the thread breaks or the bobbin thread runs out while embroidering, the machine will automatically
stop. Since some stitches may be sewn with only one thread, go back through the stitching to a point
where stitches have already been sewn before continuing embroidering.
If the upper thread breaks
a
Re-thread the upper thread. (Refer to
page 57.)
b
Touch .
→ The stitch navigating screen appears.
c
Touch to check the needle drop point
on the LCD screen.
→ The camera view window appears.
• Touch to zoom up the camera view twice the
size of normal view.
d
Touch and to go back through
the stitching to a point where stitches have
already been sewn.
1 Each touch of this key moves one stitch back
through the stitching.
2 Each touch of this key moves ten stitches back
through the stitching.
As you move to the area where your design was last
stitched, by touching the or , the
embroidery frame will move, allowing you to place
the cross mark directly on the last stitch shown.
If the Thread Breaks or the Bobbin Thread Runs Out
While Embroidering
Note
• If the thread sensor is turned off, the
machine does not stop until embroidering is
finished. Normally, the thread sensor should
be turned on. (Refer to page 233.)
• Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
Memo
• When the thread breaks or the bobbin
thread runs out while embroidering, the
spool stand LEDs flash to notify you of the
problem.
Note
• It is recommended to stitch over the top of
the last two or three stitches for complete
coverage.
1
2
Loading ...
Loading ...
Loading ...