Loading ...
Loading ...
Loading ...
Practical tips
Pausing or ending the charging process
Pr
ess the char
ging mode button
›››
Fig. 151 to
pause the charging process. The charging
connector remains locked. The charging
process can be reactivated by pressing the
charging mode button again.
If you wish to unplug the charging connector,
unlock the vehicle using the key.
If the charging ends automatically and the
high-voltage battery is charged:
●
Unlock the vehicle with the ignition switch-
ed off.
●
Remove the charging connector from the
charging socket within 30 seconds.
●
Unplug the charging cable from the power
supply source.
●
If available, replace the protective caps.
●
Close the cover of the battery charging
socket until you hear it has engaged.
Charging for the first time and charging
after not being used for a long period of
time
When the high-voltage battery is new or has
not been charged for a long period of time, it
is possible that the battery may not reach its
maximum charge level until it is charged sev-
eral times. This is due to technical reasons
and has nothing to do with any fault in the ve-
hicle.
If you are not going to use the vehicle for a
long period of time, make sure you charge the
high-voltage battery within a period of 4
months at the latest.
Note
If once the charge is completed you leave
the charging cabl
e connected, the high-
voltage battery will not discharge due to
the use of the vehicle’s electricity consum-
ers.
Fast charge at a charging station
(CC)
Fig. 152
Behind the cover of the battery charg-
ing sock
et: char
ging socket (schematic repre-
sentation).
Key to
›
›
›
Fig. 152
Charging process display
Charging socket
Protective caps
Depending on the equipment, the vehicle can
be charged with direct current (DC) at a
charging station.
The permanently installed charging cable
should not be more than 30 metres long. Take
into account the general information relating
to charging the high-voltage battery and the
preparations to be carried out before charg-
ing
›››
page 163.
Before charging the battery, always discon-
nect the drive system
›››
page 142.
Connecting the charging cable
Fast charge is carried out through the con-
nection located at the bottom of the charging
socket.
●
Remove the charging cable from the
charging station.
●
With the vehicle unlocked, press the cover
of the battery charging socket, located on
the side panel, to open it
›››
Fig. 152.
●
Remove the two protective caps from the
charging socket
›››
Fig. 152
3
. To remove the
bott
om pr
otective cap, first remove the top
cap.
●
Plug the charging connector into the
charging socket
›››
Fig. 152
2
.
1
2
3
170
Loading ...
Loading ...
Loading ...