Loading ...
Loading ...
Loading ...
in the center of the control wheel.
How to reset the time code
1. MENU → (Setup) → [TC/UB Settings] →[TC Preset], then press in
the center of the control wheel.
2. Press the (Delete) button to reset the time code (00:00:00:00).
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote
commander (sold separately).
How to set the user bit (UB Preset)
1. MENU → (Setup) → [TC/UB Settings] → [UB Preset], then press in
the center of the control wheel.
2. Turn the control wheel and select the first two digits.
3. Set the other digits following the same procedure as in step 2, then press
in the center of the control wheel.
How to reset the user bit
1. MENU → (Setup) → [TC/UB Settings] → [UB Preset], then press in
the center of the control wheel.
2. Press the (Delete) button to reset the user bit (00 00 00 00).
How to select the recording method for the time code (TC Format
*1
)
1. MENU → (Setup) → [TC/UB Settings] → [TC Format], then press in
the center of the control wheel.
DF:
Records the time code in Drop Frame
*2
format.
NDF:
Records the time code in Non-Drop Frame format.
*1
Only when [NTSC/PAL Selector] is set to NTSC.
*2
The time code is based on 30 frames per second. However, a gap between the actual
time and the time code will occur during extended periods of recording as the frame
frequency of the NTSC image signal is approximately 29.97 frames per second. Drop frame
corrects this gap to make the time code and actual time equal. In drop frame, the first 2
frame numbers are removed every minute except for every tenth minute. The time code
without this correction is called non-drop frame.
The setting is fixed to [NDF] when recording in 4K/24p or 1080/24p.
Loading ...
Loading ...
Loading ...