Loading ...
Loading ...
Loading ...
154
LOOKING AFTER YOUR HAND DRYER
WARNING
This product is not to be used in sinks where a plug is fitted. Before engaging the water
flow ensure that the plughole is clear of any obstructions and that water can drain freely.
HOW TO USE
Place your hands beneath the center of the tap and water will flow automatically for as long as
the hands remain in place.
For best dry time results:
• Place your hands to either side of the center tap to activate the hand dryer, creating sheets of
air to scrape water from your hands.
• Move your hands backwards and forwards slowly through the air, turning them over so both
back and front are exposed to the airflow.
• Keep you hands flat, close the gaps between your fingers and keep your thumbs in to ensure
that the whole of your hand is drawn through the airflow.
TROUBLESHOOTING GUIDE
WARNING: RISK OF ELECTRIC SHOCK!
Problem Action
The hand dryer fails to start. Check fuse/circuit breaker is working
and that the power is connected. Must be
performed by a qualified electrician.
Ensure the cleaning cap is removed and that
the sensors are clean and unobstructed.
If a safe method of switching is available,
turn the unit on and off. If a safe method is
not available, a qualified electrician must
perform this task.
The hand dryer is turning on and
off erratically.
Ensure sensors are clean and free
from obstructions.
Check that the sensor cable from the tap is
securely connected. Must be performed by a
qualified electrician.
The hand dryer sometimes cuts out when
in use but resumes operation after a period
of time.
Check the air inlet is clean and free of dust.
Remove any dust from the air inlet.
Ensure that the air inlet is free from
obstructions and has sufficient clearance (see
installation instructions).
The dry time of the hand dryer has increased. Inspect the inlet grille for dust and remove.
Inspect filter and change if required.
Ensure that the hose is securely attached to
the base of the tap and no leaks are present.
Must be performed by a qualified electrician.
US
USES
AR
CL
GT
MX
PA
NOTE: Ensure that the water feed is completely flushed of debris, copper filings etc.
prior to connecting to the product. Failure to do so will damage the solenoid valve.
The instructions in this manual and the installation guide must be followed completely,
as failure to do so may result in incorrect operation, damage to property and/or
personal injury. It is recommended that an isolation valve is fitted with this product
during installation. Dyson will not be held liable for any damage to property or
personal injury, or any loss of business or revenue, if you, your staff, your installer
or service technician have not followed the instructions given in this manual and the
installation guide.
27.11.2017 12:51 - C92757_WD04_OPMAN_INT_X588-OWNERS-MANUAL-PART 3- TEXT.indd_15_0c2s_15_0c2s
Loading ...
Loading ...
Loading ...