Loading ...
Loading ...
Loading ...
US
USES
AR
CL
GT
MX
PA
309
Test the hand dryer for normal operation:
– Place your hands beneath the center of the
tap and water will flow automatically for as
long as the hands remain in place.
– Place your hands to either side of the
center tap to activate the hand dryer,
creating sheets of air to scrape water from
your hands.
– Move your hands backwards and forwards
slowly through the air, turning them over
so both back and front are exposed to
the airflow.
Automatic duty flush
The unit is equipped with a fixed automatic
water flush, which activates for 60 seconds 24
hours after last use. This helps reduce water
stagnation and bacteria proliferation within
the product.
Please ensure that the unit is always installed
over a functional basin with free and
connected drainage.
Hand dryer fails to start:
– Check fuse/circuit breaker is working
and that the power and water supply
are connected.
– Ensure the cleaning cap is removed and that
the sensors are clean and unobstructed.
– Turn the unit off and on.
Hand dryer turns itself on and
off erratically:
– Turn the unit off and on.
– Ensure there is no plug in the sink and
remove if plug is present.
– Ensure sensors are clean.
– Check that the sensor cable from the tap is
securely connected.
Hand dryer sometimes cuts out in use:
– Turn the unit off and on.
– Ensure sensors are clean.
– Check the air inlets are clean and free
of dust. If the air inlets are dusty simply
remove dust.
– Ensure that the air inlets are free from
obstructions and have sufficient clearance.
The dry time has increased:
– Inspect the air inlets for dust and remove.
– Inspect filter and change if required.
– Ensure that the hose is securely attached to
the base of the tap and no leaks are present.
The airflow is running hotter than usual:
– Inspect the air inlets for dust and remove.
– Inspect filter and change if required.
– Ensure that the hose is securely attached to
the base of the tap and no leaks are present.
Air is continuously running:
– Check for any object in the sink and remove
if necessary.
– Ensure sensors are clean and free from
any obstructions.
– Inspect filter and change if required.
– Ensure that the hose is securely attached to
the base of the tap and no leaks are present.
There is no air running:
– Turn the unit off and on.
– Check fuse/circuit breaker is working and
that the power is connected.
– Ensure sensors are clean.
– Ensure that the air hose is securely attached
to the base of the tap and no leaks
are present.
– Check that the sensor cable from the tap is
securely connected.
Water is continuously coming from the tap:
– Ensure sensors are clean and free from
any obstructions.
There is no water coming from the tap:
– Ensure that the power and water supplies
are turned on and that the isolation valve
is open.
– Ensure that the aerator is free from debris,
remove and clean/replace if necessary.
The water coming from the tap is overly hot
or cold:
– Check the blender valve is set to the
desired temperature.
Contact Dyson Customer Care for further
support and information or online at
www.dyson.com
TroubleshootingTest
installation
Loading ...
Loading ...
Loading ...