Loading ...
Loading ...
Loading ...
(374,1)
北米Model "A1360BE-A" EDITED: 2018/ 8/ 31
the air pressure to the appropriate level
(green zone of the air gauge).
CAUTION
. Do not run the air compressor for
more than 10 minutes as it can
get hot. Be careful not to get
burned.
. If tire pressure doesn’t reach the
green zone for 10 minutes, this kit
will be unable to seal the tire.
Please contact your SUBARU
dealer for help.
NOTE
. After the compressor starts to oper-
ate, the air pressure will temporarily
rise to 45 psi (300 kPa, 3.0 kgf/cm
2
) or
higher. After about 30 seconds when all
of the sealant is inside the tire, the air
pressure will lower, representing the air
pressure in the tire.
. In extremely low temperatures −228F
to −48F (−308C to −208C), the viscosity
of the sealant increases and the sealant
will flow more slowly. In such tempera-
tures, bring the sealant into the vehicle
to warm it up before use.
. When mending the tire, if the air
pressure gauge is hard to read, turn the
compressor switch off once to get an
accurate reading.
5. While filling the tire with air, attach the
speed limit label on the position shown in
the illustration.
WARNING
Do not attach the speed limit label in
a position where the label hides the
warning lamp or on the steering
wheel. It may interfere with the
normal operation of the airbag and
lead to a critical failure.
6. Turn the air compressor power switch
off when the air pressure reaches the
green zone of the air gauge.
Remove the power plug from the acces-
sory power socket.
Remove the hose after filling the tire with
Flat tires
372
Loading ...
Loading ...
Loading ...