Loading ...
Loading ...
Loading ...
(166,1)
北米Model "A1360BE-A" EDITED: 2018/ 8/ 31
& Arming the system
S02AF04
The alarm system becomes armed when
the following operation is performed.
1. Close all windows and the moonroof (if
equipped) and turn the ignition switch to
the “OFF” position.
2. Carry the access key fob and get out of
the vehicle.
3. Make sure that the engine hood is
closed.
4. Lock the doors using any of the
following methods.
. Locking using the remote keyless
entry system. For details, refer to
“Remote keyless entry system”
FP156.
. Locking using the keyless access
function. For details, refer to “Locking
with the door lock sensor” FP147.
. Locking using the power door lock-
ing switch. For details, refer to “Locking
using power door locking switch”
FP161.
Security indicator light
NOTE
. All doors and the rear gate will lock,
an electronic chirp will sound once, the
hazard warning flashers will flash once,
and the security indicator light will start
flashing rapidly.
. If any of the doors or the rear gate is
not fully closed, an electronic chirp
sounds five times and the hazard
warning flashers flash five times to
indicate that the doors (or the rear gate)
are not properly closed. When the
doors are closed, doors will automati-
cally lock.
5. Approximately 30 seconds later, the
system will enter surveillance state.
When the system is in surveillance state,
the security indicator light will then flash
slowly (twice approximately every 2 sec-
onds), indicating that the system has been
armed for surveillance.
NOTE
. The system can be armed even if the
windows and/or moonroof are open.
Always make sure that they are fully
closed before arming the system.
. The 30-second standby time can be
eliminated if you prefer. Have it per-
formed by your SUBARU dealer.
. If any of the following actions is
done during the standby period, the
system will not switch to the surveil-
lance state.
– Doors (including the rear gate)
are unlocked using the access key
fob.
– Doors (including the rear gate)
are unlocked using the keyless
access function.
– Any door (including the rear gate)
is opened.
– Push-button ignition switch is
turned to the “ACC” position.
& Disarming the system
S02AF05
Perform either of the following procedures.
. Briefly press a button (for less than 2
seconds) on the access key fob.
Alarm system
164
Loading ...
Loading ...
Loading ...