Loading ...
Loading ...
Loading ...
NORMA 6003/NORMA 6003+/NORMA 6004/NORMA 6004+
Users Manual
46
Select the Waveform to Display
Up to 4 waveforms can be displayed simultaneously on the screen, and the user can select 1 to 4 items
from all available items for display.
Enter the Signal Menu:
• From the main screen of Scope select 2 (Signal).
The Signal menu lists all currently available parameters, including voltage and current for
example.The specific parameters depend on the current system configuration. See
Set the Wiring
Selection
.
Select the Waveform to Display:
1. In the Signal menu, select up to 4 parameters:
a. Use the arrow (K L M N) keys to move the cursor over the corresponding item.
b. Push S, the selection box of the current item turns yellow and a black “×” symbol is
appears, indicating the selection. To remove a selection, push S again, the selection box
will be cleared.
When a parameter is selected or cleared, the state is reflected in the waveform screen.
2. Push J to go back to the main screen of Scope.
Note
If 4 signals are selected, all other signals are grayed out. When you push the arrow (K L M N)
keys, the cursor can only move among the selected 4 signals. To select a different signal, you
must clear 1 of the 4 signals and then add a new one.
Trigger Setup
Use Trigger to determine when the Analyzer should start displaying waveforms on the screen so that
the waveforms displayed by each refresh can be aligned. Once the set trigger condition is met, the
screen is triggered, the waveform displayed on the screen is aligned at that point.
The Analyzer offers a variety of trigger methods to support multiple trigger sources and trigger modes.
Enter the Trigger Setup Menu:
• From the main screen of Scope select, 3 (Trigger).
The options are as shown in
Table 20.
Table 20. Trigger Setup
Item Description
1 Source
Push 1 (Source) to cycle through the current trigger sources.
The currently selected trigger source is shown under the “Source” label
with a color block of the same color as the waveform.
The selectable trigger sources are the selected signal in the “Signal”
menu, which is the signal displayed on the “Vertical Axis Scale” of the
screen, see
Select the Waveform to Display.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...