Loading ...
Loading ...
Loading ...
PERIODIC MAINTENANCE 2-63
Periodic Maintenance Procedures
Spark Plug Replacement
•
Remove the stick coils (see Stick Coil Removal in the
Electrical System chapter).
•
Remove the spark plugs using the 16 mm (0.63 in.) plug
wrench [A] vertically.
•
Replace the spark plugs with new ones.
Standard Spark Plug
Type:
NGK CR9EIA-9
•
Insert the spark plug vertically into the spark plug hole
with the spark plug installed in the plug wrench [A], and
finger-tighten it first.
NOTICE
If tightening the spark plug with the wrench in-
clined, the insulator of the spark plug may break.
•
Tighten:
Torque - Spark Plugs: 13 N·m (1.3 kgf·m, 115 in·lb)
•
Install the stick coils (see Stick Coil Installation in the Elec-
trical System chapter).
•
After installation, be sure the stick coils are installed se-
curely by pulling up them lightly.
Others
Chassis Parts Lubrication
•
Before lubricating each part, clean off any rusty spots with
rust remover and wipe off any grease, oil, dirt, or grime.
•
Lubricate the points listed below with indicated lubricant.
NOTE
â—‹
Whenever the vehicle has been operated under
wet or rainy conditions, or especially after using a
high-pressure water spray, perform the general lubri-
cation.
Pivots: Lubricate with Grease.
Brake Lever
Brake Pedal
Clutch Lever
Rear Master Cylinder Push Rod Joint Pin
Side Stand
Points: Lubricate with Grease.
Clutch Inner Cable Upper and Lower Ends [A]
Throttle Inner Cable Upper and Lower Ends
Loading ...
Loading ...
Loading ...